ges load to my last message full transcripthighlights Feeds Mon 19:59 1 Q: How to obtain torque constant for stepper motor? I want to measure the torque constant of a stepper motor but seems I […]

Q: How to obtain torque constant for stepper motor? I want to measure the torque constant of a stepper motor but seems I am doing it wrong. I have an MST342C02 stepper motor […]

Feeds Mon 19:59 1 Q: How to obtain torque constant for stepper motor? I want to measure the torque constant of a stepper motor but seems I am doing it wrong. I have […]

Nema17 – Frequency – Temperature issue Hi i am trying to use MCPWM to move a nema 17 motor with esp32. I am using a TB6560 stepper motor driver and it setup […]

Is it a good idea to drive 24VAC solenoid valves with triacs? Ask Question Asked today Modified today Viewed 42 times 0 I want to build irrigation system for my garden. Most solenoid valves for […]

tlfong01 6962 Fri 10:14 So I now know how to use a stepper motor to move a flap 180 degrees. However I found the stepper motor is too bulky, and seems not […]

highlights Justin Priede 361 Fri 10:14 @Milliways the code I have provided works, it is connected to my two motors and interacts with them however I tell them. I did realize these […]

Feeds Fri 10:14 0 Q: Consistent Motor control – specifically 180 degrees I am struggling to get my motors to perform the same on each run. The first time I run the program, […]

Q: Consistent Motor control – specifically 180 degreesJustin PriedeI am struggling to get my motors to perform the same on each run. The first time I run the program, they will perform […]

Feeds 10:14 0 Q: Consistent Motor control – specifically 180 degrees I am struggling to get my motors to perform the same on each run. The first time I run the program, they […]