Identify LED driver IC / manufacturer Logo

Ask QuestionAsked todayActive todayViewed 59 times0

i am interested in an LED driver IC. It drives a 40W E27 LED with a 12V fan. The logo looks like a kind of “JD” the IC number is difficult to read: something “960?S” (see pciture). It seems to drive a buck converter with a two volt output…

Any hint would be greatly appreciated.

best regrads

driverShareCiteEditFollowFlagasked 5 hours agoDominik Schuierer111 bronze badge New contributorAdd a comment

2 Answers

ActiveOldestVotes1

Most likely it’s a Chinese-made primary-side regulated (PSR) constant-current flyback converter chip with internal MOSFET. It won’t be easy to find the brand/model or even a datasheet, but there are numerous chips of this type in the market.

There’s a 2R2 1% resistor. Probably it sets the output (LED) current.

M7 diodes (D1..D4) are kinda SMD equivalent of 1N4007. There are 4 of them. At first, I thought that they form a bridge rectifier because there are two white cables coming to that side (probably AC voltage input) and a big electrolytic capacitor (could be a few micro Farads, 400/450V). But the PCB tracks don’t look like so.

D5 (couldn’t read its model) could be either a part of the snubber block or rectifier diode coming from the aux winding for chip supply ^{I don’t see a small capacitor for this purpose, though}. So I’m not sure what D5 does.

The 39k resistor to the ground probably determines the open (unloaded or maximum) output voltage, since (as you said) it’s an LED driver. One of the main problems of constant-current LED drivers is LED disconnection which leads the output voltage to rise until the circuit breaks down. So the converter should sense and thus limit the output voltage. This helps to limit the output power as well since the internal MOSFET can easily thermally run away.

The secondary side is blocked by your thumb. So I can’t make a guess. But I see an electrolytic capacitor, and probably there’s a rectifier diode plus a bleeder resistor.ShareCiteEditFollowFlagedited 3 hours agoanswered 3 hours agoRohat Kılıç10.3k33 gold badges1717 silver badges3737 bronze badgesAdd a comment0

Answer

1. I asked PhotoShop for help, but no luck.
2. The logo looks like “D”.
3. The Q&As in Ref 1, Ref 2 below and the schematic might help a bit.

4. Another typical transformerless AC to DC LED driver schematic

5. Constant Current Light Transformer AC200-240V Power Adapter For LED Bulb DIY – AliExpress]6

References

(1) What’s the voltage used to power LEDs inside an LED light bulb? Asked 3 months ago Active 3 months ago Viewed 179 times

(2) Is this power supply suitable for powering these chip on board (COB) LEDs?　Asked 13 days ago　Active 11 days ago　Viewed 351 times

(3) How can Rpi Python PWM GPIO pins control and dim LED strips of 1W 350mA? – EESE 2021mar13

(4) Transformerless AC/DC Constant Current Driver MBI6001 – ÓMacroblock 2003jan

(5) Constant Current Light Transformer AC200-240V Power Adapter For LED Bulb DIY – AliExpress

ShareCiteEditDeleteFlagedited just nowanswered 5 hours agotlfong011,78011 gold badge66 silver badges1313 bronze badges

• 4This actually is not an answer. – Chupacabras 4 hours ago
• 1@Chupacabras there is no way to include an inline image in a comment – jsotola 3 hours ago

Add a comment