Uncategorized

Rpi power bank notes

Asked 
Active today
Viewed 26 times
1

I am trying to make a simple robotic car with my raspberry pi. The problem is that when it reaches the white load up screen it immediately reboots itself over and over again.

My raspberry pi is powered through a 9V battery which goes through a voltage regulator (LM350T 5V) and connects to the 5V GPIO pin on the pi. My multimeter shows 4.77V and 1.37A delivered to the raspberry pi. I’ve read that as long as it’s over 4V the pi shouldn’t reboot itself so I’m not sure why this is happening. Any advice is much appreciated.

 New contributor
  • 2
    Hi @dlam0002 ,Welcome and nice to meet you. Ah, let me see. Your 9V battery is running out. I suggest using 3 rechargeable 16450 batteries in series. 3.7V x 3 = 11.1V should be good. However LM350T is bad, because it is a series regulator which wastes power. Let me see, if Vin = 9V, Vout = 5V, then 9V – 5V = 4V == 4V/9V == 35% energy is WASTED as heat energy. I would suggest to use LM2596 switching regulator which has 90% efficiency: aliexpress.com/i/32895338514.html. Now input can still be 9V or 11.1V, and adjust output voltage to about 5.2V, and your Rpi will be loving it. – tlfong01 1 hour ago   
  • Thanks I will try this! – dlam0002 10 mins ago
  • Your are welcome. I see that you are making a robot car. Let me give you more links that you might be interested. The first link on “How to build a buggy” is very good for newbies. (1) raspberrypi.stackexchange.com/questions/98513/… (2) raspberrypi.stackexchange.com/questions/99460/… (3) raspberrypi.stackexchange.com/questions/96515/…, There is also a suggestion to DIY a 16450 power bank. – tlfong01 2 mins ago   Edit   
  • There is also a suggestion to DIY a 16450 power bank. In case you wonder why I use 16450 x 3 = 3.7V x 3 = 11.1V to step down to 5V and not 16450 x 2 = 3.7V x 2 = 7.4V and step down to 5V. The reason is that the switching regulator won’t waste that much more energy either from 11.1V to 5V or 7.4V to 5V. If you use 11.1V to start with, you have a bigger margin for the voltage to drop to say 6.5V, you can still go well. On the other hand, 7.4V cannot drop that much percentage and still go well. You may serach for “L298N” in this forum for more suggestions on using power banks for robot cars. – tlfong01 just now   Edit   

0

It reboots because there is not enough power.

Find a better power supply.

Categories: Uncategorized

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

This site uses Akismet to reduce spam. Learn how your comment data is processed.

%d bloggers like this: